This is the ultimate ’go-to’ plug and play coil upgrade kit on the market. Don’t be fooled with other cheaper kits on the market that does not fit under the valley cover, does not seal the spark plug bore, utilizes the incorrect stalk or, worse, counterfeit coils.

What differentiates us from other competitors:

• True Bolt On - 100% Plug and Play for effortless installation.
• Genuine Hitachi VR38 R35 GTR coil packs.
• Billet aluminium 6061 mounting bracket, hard anodised black with a choice of dress up washer color.
• Custom triple sealing coil stalk lower to stop moisture/debris getting into the spark plug bore with the right inner diameter to fit BCPR or BKR spark plugs (original VR38 R35 uses smaller spark plug stem diameter which requires excessive force to jam the coil onto the larger spark plug stem diameter found on BCPR or BKR spark plug which often cracks the plastic).
• Rigid coil stalk mids that meets or exceeds OEM standard for dielectric strength and dimensionally stable at all operating temperature retaining the spring and resistor within.
• Fits under the spark plug valley cover.
• Coil kit and its mounting system sits low in the valley allowing ample clearance for HKS VCAM system.
• Heavy gauge, high temperature and chemical resistant Teflon F.E.P wiring harness constructed with nylon sleeving and dual wall heat shrink.
• Genuine connectors.
• Professionally crimped terminals.

Note(s)

• Known supported ECUs: Almost all modern aftermarket ECUs that allows you to configure ignition dwell time.
• Check up tune on your vehicle is highly recommended. Depending how old/weak your previous coils are, our testing shows an advancement of the ignition base timing by installing these powerful coils.
• Designed to be used with the recommended spark plugs by Nissan i.e. NGK BCPR series.
• Minor trimming of the valley cover plastic rear section is required on RB20 and RB25 (refer to ’figure 10’ in instruction guide).
• To maximise its performance, the ignition dwell time table for the R35 GTR coil is provided under the ’installation guide’ tab
• We do NOT sell individual components separately due to the custom components and fitment.
• We may combine ignition coils into one box to save on international shipping (reduced volumetric weight)
• We do not sell and recommend the use of counterfeit coil packs. Counterfeit products harm the automotive industry and are a hazard to your engine/safety. Be cautious when a seller uses words like “-style” or “-equivalent” to pass on cheap counterfeit products that will not perform.
• We do not incorporate a wire loop in our harnesses for use with an inductive timing light as our experience proves it to be an unreliable source. To set ignition base timing, we recommend the use of coil on plug extension lead (such as DAT-Equipment TE010 or the like) to latch your inductive clamp onto for a much more reliable reading.
• RB25 NEO head have different coil bolting points, please verify your coil mounting on your cylinder head before purchasing